I have an HP LaserJet 1320 that won't print - Any suggestions?

When I send a job to the printer, the paper goes through, but does not have anything on it when it comes out. I placed the toner in another printer and everything was fine. I get the same outcome if I try to print a test page from the printer itself.I have an HP LaserJet 1320 that won't print - Any suggestions?
To change the default settings for all future print jobs in Windows XP


1. In the Windows task bar, click Start, and click Printers and Faxes.


2. Right-click the HP LaserJet 1160 or HP LaserJet 1320 series printer icon.


3. Click Properties, or click Printing Preferences.


4. Change the settings, and click OK.





The printer control panel is comprised of four lights and two buttons. The hp LaserJet 1320nw printer has an additional light at the top of the control panel. These lights produce patterns that identify your printer's status.


1 Wireless light: (HP LaserJet 1320nw printer only) When the Wireless light is on solid, a wireless connection has been established. When the Wireless light is off, wireless operation is disabled.


When the Wireless light is flashing, the printer is trying to establish a wireless connection.


2 Toner light: When the toner is low, the Toner light is on solid. When the print cartridge is out of the printer, the Toner light is flashing.


3 Attention light: Indicates printer media input tray is empty, print cartridge door is open, print cartridge is missing, or other errors.


4 Ready light: Indicates that the printer is ready to print.


5 GO button and light: To print a demo page or to continue printing while in manual feed mode, press and release the GO button. To print a configuration page, press and hold the GO button for 5 seconds.


6 CANCEL button: To cancel the print job that is currently printing, press the CANCEL button.


for more detail go to http://h20000.www2.hp.com/bc/docs/suppor鈥?/a>


good luck , if these informations help you.I have an HP LaserJet 1320 that won't print - Any suggestions?
if the drum kit is ok then it may be a PSU problem or the formater. both these need a workshop.





I am not sure how much the 1320 is but it may pay you to replace the printer